ASTM & ASHTO Tests. • 3). Why So Many Sealants. • 4). . ASTM. 5 specifications for Crack Seal. • ASTM D • ASTM D Type I. • ASTM D Type II. CrackMaster™ Type I. The ideal product for the contractor who wants a single product to use in both road and parking lot applications. Meets ASTM D Designation: D – 07Standard Specification for Joint and Crack Sealants, Hot Applied, for Concrete and Asphalt Pavements.
|Published (Last):||23 June 2017|
|PDF File Size:||11.51 Mb|
|ePub File Size:||1.21 Mb|
|Price:||Free* [*Free Regsitration Required]|
Elastoflex 61 Best Performance.
Joint Sealants When concrete roads are poured, it is important that transverse and longitudinal joints be cut while the concrete is still green in order to control where the concrete cracks. Solution Center Common Problems.
How to fix a pothole How much does it cost to fix a pothole? Historical Version s – view previous versions of standard.
Maxwell Products – Concrete Joint Sealants
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Though necessary, these cuts create a penetration point for water that needs to be sealed to prevent damage to the road base. It is informational only and not an 6d690 part of the standard; the full text of the standard itself must be referred to for its use and application.
Sizes Available 50 lb. Use the following chart as a guideline for estimating material requirements based upon pounds of material needed for feet of cracks: This abstract is a brief summary of the referenced standard. Use with adequate ventilation. Elastoflex 51 Best Performance. Mixing Procedures Use material as supplied. Brands Elastoflex Nuvo Gap. The ideal product for the contractor who wants a single product to use in both road and parking lot applications. For best results the sealant depth to width ratio should not exceed 2 to 1 i.
Actual material usage may vary due to width of application and thickness of material above pavement surfaces. While there are many types of sealants, some of the most effective are hot-pour, asphalt based sealants. Some features of this site will not work with this browser. How often should you sealcoat a parking lot or driveway? atm
CrackMaster™ Type I – SealMaster
Hard hat with face shield; long sleeved shirt buttoned at the wrist; heat resistant gloves; long, cuffless pants; and safety toed work boots. Locate Installers Contact a Location.
Compare to my climate. This specification covers four types of joint and crack sealants of the hot applied type intended for use in sealing joints and cracks in Portland cement concrete and asphaltic concrete pavements. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine d66690 applicability of regulatory requirements prior to use.
CrackMaster™ 6690 Type I
Support Solution Center Contact Us. The above coverage rates are only a guideline. Nuvo Spec Best Performance. Company About Us Jobs. World-Class pavement maintenance products. When concrete roads are poured, it is important that transverse and longitudinal joints be cut while the concrete is still green in order to control where the concrete cracks.
Using a sealing shoe or squeegee, band the material 2 d669 3 inches wide over the crack. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
No other units of measurement are included in this standard. Link to Active This link d66690 always route to the current Active version of the standard. Technology Polyskin ZipBox Intelibond. CrackMaster Type I forms a lasting seal that resists tracking in warm climates.
Asphalt Pavement Concrete Pavement. The extremely hot material will cause severe burns on contact with skin. Do not blend with other materials. Use material as supplied.