ASTM D covers the determination of tear strength or tear resistance of flexible plastic film and sheeting. The site of tear is initiated by a high stress. GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Standard Test Method for Initial Tear Resistance of Plastic Film and Sheeting. ASTM D Standard Test Method for Tear Resistance (Graves Tear) of Plastic Film and Sheeting.
|Published (Last):||1 April 2009|
|PDF File Size:||7.52 Mb|
|ePub File Size:||18.27 Mb|
|Price:||Free* [*Free Regsitration Required]|
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part 1d004 the standard. Please confirm that you agree with our privacy and cookies policy to submit this form. Die C specimens are commonly used.
Evaluating how your products and services meet and exceed quality, safety, sustainability and performance aastm. The specimen geometry of this test method produces a stress concentration in a small area of the specimen.
Active Risk Management
The specimen geometry and speed of testing in this test method are controlled to produce tearing in a small area of stress concentration at rates far below those usually encountered in service. Non-repeatability of results — ASTM D requires the operator to exclude results that deviate markedly from the mean value. For this test, we recommend a Series or Series single aatm electromechanical frame.
Subscribe to Our Newsletters. It is often used for quality control checks or for material comparison where tear failures are possible.
Tear Resistance ASTM D
Contact Us View Accessories Catalog. This test method aims to measure force to initiate tear for plastic films that do no exhibit brittle failure or do not elongate greater than The challenges of testing to this standard are: It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Concrete, Asphalt and Rock.
Bluehill Universal Software is built from the ground-up for touch interaction and an intuitive user experience. Instron self-tightening grips are primarily designed for the precision testing of films and other flexible materials exhibiting a large reduction in cross-section area under load.
Send us a request Need help or have a question? Experience has shown the test to have its best reliability for materials which do not have brittle failure or do not elongate greater than two hundred percent during testing. The method is not applicable for film or sheeting material where brittle failures occur during testing or where maximum extension is greater than They are designed with standard and optional features that increase testing efficiency and improve the testing experience for the operator.
Instron ASTM D Plastic Film and Sheeting – Instron
Historical Version s – view previous versions of standard. Email addresses must contain the symbol. Actual use performance in tearing of some plastics may not necessarily correlate with data from this test method.
Next Checking to see if you are a returning visitor…. Assurance E1004 Inspection Certification. Therefore, it is advisable to refer to that material specification before using this test method.